Toshiba 3511 用户手册

November 2003  ©  TOSHIBA TEC

3 - 65

e-STUDIO3511/4511 ADJUSTMENT

When operating the reverse solenoid, adjust it if the position of the flapper lever is out of the following

dimension.

Gap between A of the front frame and the flapper lever “C”:  0.5 mm to  2.0 mm

Adjusting procedure

(1)

Remove the screw on the left and take off

the plate spring.

(3)

While the plunger of the reverse solenoid is

put in the position to be turned ON (by

pressing it in the direction of an arrow),

loosen the screw on the right to adjust the

reverse solenoid so that the gap (C)

between A of the front frame and the flapper

lever is 0.5 mm to 2.0 mm.

(2)

Align B of the front frame with the edge of

the reverse solenoid, and temporarily fix the

reverse solenoid with the screw on the right.

C

A

B

Plate spring