Datamax E-4304 用户手册
E-4203/E-4204/E-4304
9
3.2 Loading Media
1. Open the cover.
2. Push the Printhead Latch down
and raise the Printhead Carrier
Assembly.
Assembly.
3. Place a roll of media (labels
facing up) on the Media Hub and
insert them into the printer. Slide
the Media Hub Flange with its
smooth side towards media onto
the Media Hub.
insert them into the printer. Slide
the Media Hub Flange with its
smooth side towards media onto
the Media Hub.
4. Route the media as shown below.
5. Slide the Media Guide and Hub Flange to the edge of the media.
6. Close the Printhead Carrier Assembly and press down until it locks into place.
7.
Close the cover and press the ‘Feed’ button several times to feed the media and
ensure proper tracking. If the printer does not correctly sense the top of each
label it may be necessary to perform the Calibration Procedure, Section 4.6.
ensure proper tracking. If the printer does not correctly sense the top of each
label it may be necessary to perform the Calibration Procedure, Section 4.6.
Note:
The printer is factory set for 4-inch media and ribbon, when using
different width media/ribbon please refer to Chapter 5.
different width media/ribbon please refer to Chapter 5.