Canon BJ-10sx 用户手册

This appendix lists the control codes and ESCape sequences you can use 
in BJ-10e mode and Epson LQ mode, and shows the character sets 
available in each mode. For a complete description of these 
programming commands, you can order the Canon Bubble Jet Printer 
BJ-10sx Programmer's Manual. Call the Canon help desk at 1-800-423-
2366 to order this manual 

Control codes and ESCape sequences tell the printer how to print a job. 
You send commands to the printer in one of two ways: 

z

You can use your application software to automatically embed 
certain commands (such as bold, underline, or indent) within a 
document. When the document prints, the embedded command 
control the way the printer produces the printed page. Refer to 
your application software manual for instructions on sending 
commands.

z

You can send specific commands directly to the printer, using 
either a BASIC programming statement or a printer command 
option in your software. 

You can use the control codes and ESCape sequences listed in the 
following table when the printer is in BJ-10e mode; that is, when DIP 
switch 11 is set to OFF. In this mode, the printer can emulate either the 
IBM Proprinter X24E (DIP switch 10 OFF) or the Canon Bubble Jet 
Printer BJ-130e (DIP switch 10 ON). Differences between IBM 
Proprinter X24E emulation and Bubble Jet Printer BJ-130e emulation 
are described following the command summary tables.