Citizen Systems PMU2XXX 用户手册

 

- 65 - 

 

 

Defining the print area in PAGE MODE

 

 

[Code] 

<

1B>H<57>H<xL><xH><yL><yH><dxL><dxH><dyL><dyH> 

 

[Range] 

0≦xL、xH、yL、yH、dxL、dxH、dyL、dyH ≦255 

except for dxL = dxH = 0 or dyL = dyH = 0 

 

 

 

Defines the location and size of the print area. 
• Horizontal start point = [(xL+xH×256)×basic calculation pitch] inches 
• Vertical start point = [(yL+yH×256)×basic calculation pitch] inches 
• Horizontal length = [(dxL+dxH×256)×basic calculation pitch] inches 
• Vertical length = [(dyL+dyH×256)×basic calculation pitch] inches 

 

 

• When STANDARD MODE is selected, this command only executes the internal flagging of the 

printer without affecting the printing in STANDARD MODE.

 

• If the horizontal start point or vertical start point is out of the printable area, this command is 

canceled and the next data is handled as normal data.

 

• If the horizontal length or vertical length is 0, this command is canceled and the next data is 

handled as normal data.

 

• The character mapping position will be the start point specified by ESC T in the print area.

 

• If the “horizontal start point + horizontal length” is greater than the horizontal printable area, the 

“horizontal printable area – horizontal start point” is taken as the horizontal length. 

• If the “vertical start point + vertical length” is greater than the vertical printable area, the “vertical 

printable area – vertical start point” is taken as the vertical length.

 

• The basic calculation pitch is defined by GS P. Once defined, the print area is not changed if the 

basic calculation pitch is changed by GS P.

 

• Fractions resulting from calculations are corrected with the minimum pitch of the mechanism, and 

the remainder is omitted.

 

• The horizontal start point and horizontal length are calculated with the basic calculation pitch (x). 

The vertical start point and vertical length are calculated with the basic calculation pitch (y). 

• The figure below illustrates the print area, where X = horizontal start point, Y = vertical start point, 

Dx = horizontal length, and Dy = vertical length. 

 

（

X、Y） 

Paper

 

Dx 

Dy 

Prin

 
 
 
 
 
 
 
 

• The printable area is approximately 117 mm (938/203 inches) vertically, and horizontal area 

depends on the model. (Refer to the below Table)

 

t 

（

X+Dx-1、Y+Dy-1） 

Paper feed direction