Xerox FS-C8008N 用户手册

B-9

After you procure an RS-232C cable, check its wiring against the pin assignments shown in 
page 

. If you have an IBM communications 

adapter cable type 1502067, use the procedure below to solder the wiring at the end (printer 
side) of the cable:

1

11

1

Unscrew the plastic cover at the end (printer side) of the cable.

2

22

2

A bare shield wire is provided for each wire in the cable. Solder all shield wires 
together into a single bundle.

3

33

3

Connect the bundled shield wires to the connector metal face using a piece of flat 
cable about 3 mm wide and 15 mm long,. Make sure that the soldered connections 
are secure.

4

44

4

Unsolder wires 2 and 3, then resolder them in a crossover configuration. In other 
words, solder wire 2 to pin 3 and wire 3 to pin 2. Cover the solder joints with a 
thermofit tube. 

5

55

5

Cut wires 4, 5, 6, and 20.

6

66

6

Solder wires 5 and 6 together and connect them to pin 20. Cover the solder joints 
with a thermofit tube. Leave wire 4 unconnected.

7

77

7

Tape all remaining loose ends together, or seal them with a thermofit tube.

8

88

8

Screw the plastic cover back on the cable end.

Make sure that both computer and printer are powered off.

1

11

1

Discharge static electricity from your body by touching a metal object such as a 
doorknob.

2

22

2

Plug the end (printer side) of the RS-232C cable into the printer's serial interface 
connector and screw it on securely.

3

33

3

Plug the other end of the cable into the computer’s serial interface connector.

4

44

4

Power on the printer.

5

55

5

The printer’s parameters are set at the factory as follows:

Baud rate = 9600 bps, data bits (character length) = 8, stop bits = 1, parity = none

The two RS-232C protocols are XON/XOFF and DTR. The printer executes both of 
these protocols simultaneously, using positive logic for DTR.