Xerox CX 用户手册
Note: The page number that was previously in the target location is not
automatically moved to another location. To retain this page, manually move
this page to a new location.
automatically moved to another location. To retain this page, manually move
this page to a new location.
If you have a duplex job and the Apply changes to front and back check
box is selected, the page number for the back side of the page also
changes. Using the example above, page 6 would be on the back side of
page 5.
box is selected, the page number for the back side of the page also
changes. Using the example above, page 6 would be on the back side of
page 5.
Simulating a job with your template
You can simulate how jobs from the Storage window will look if
you apply an imposition template to them.
you apply an imposition template to them.
Note: The imposition template parameters are not actually applied to the job
—you are viewing only a simulation of how the job would look if this template
were selected on the Imposition tab.
—you are viewing only a simulation of how the job would look if this template
were selected on the Imposition tab.
1. In the Imposition Template Builder window, click the Simulate
button.
2. Click Browse.
3. Select a job, and then click Select.
3. Select a job, and then click Select.
The parameters of the job (Sheet Size, Trim Size, Trim
Orientation, Sets per sheet, Bleed Size, Rotate 90, Crop
Marks, and Fold Marks) appear with their values in the
Simulate Imposition window.
Orientation, Sets per sheet, Bleed Size, Rotate 90, Crop
Marks, and Fold Marks) appear with their values in the
Simulate Imposition window.
Note: Both RTP and non-RTP jobs are available for simulation.
4. Change the parameters as desired.
5. Click View Simulated Job.
5. Click View Simulated Job.
The Preview window appears. A simulation of the job is displayed
with the current imposition template applied.
with the current imposition template applied.
Print with exceptions
Adding exceptions to your job
Exceptions are used when you want to use different media types
for special exceptions within a job, or add inserts.
for special exceptions within a job, or add inserts.
Note:
1. Open the Job Parameters window of your job.
2. Click Exceptions.
2. Click Exceptions.
Simulating a job with your template
83