Xerox 75 MX 用户手册
Operator Guide
Product overview
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
3-11
Stapling
Removing any of the output while the printer is running may
produce finished sets that are incorrectly stapled.
produce finished sets that are incorrectly stapled.
To ensure that the stapling of thin sets is satisfactory, the printer
performs the following actions.
performs the following actions.
After 30 finished sets of 15 sheets, the printer:
1. cycles down
2. raises a message to empty the Stacker
3. waits until the sets are removed
4. raises the Stacker Tray
5. cycles up and resumes printing.
If these parameters are not satisfactory for your printing, contact
Xerox.
Xerox.
Staple placement
For information about the limitations of portrait and landscape
staple placement, refer to the Staple Placement table below.
staple placement, refer to the Staple Placement table below.
Table 3-1. Staple placement
Edge Feed
Orientation
Orientation
Media Size
Portrait
Staple
Staple
Landscape
Staple
Staple
Dual
Portrait
Staple
Portrait
Staple
Dual
Landscape
Staple
Landscape
Staple
Long
8.5x11
FAULT
FAULT
Long
8.5x14
N/A
N/A
N/A
N/A
Short
8.5x11
FAULT
FAULT
Short
8.5x14
FAULT
FAULT
Short
11x17
FAULT
FAULT