Xerox 8850 用户手册
6
•Getting to know the WIDE FORMAT COPY SYSTEM
XEROX WIDE FORMAT COPY SYSTEM
A. Standard Stacker
The Stacker is located at the rear of the Scanner. When the
AUTORETURN feature is set to REAR, documents exit the Scanner onto
the Stacker. The Stacker can be adjusted to any one of four positions by
raising or lowering it. The height of the Stacker should be adjusted to
accommodate the document being scanned. It has two extensions at its
end that can be pulled out to accommodate longer documents (up to size
E or A0). When scanning most common weight (20 lb, 80gsm)
documents, move the Stacker to the 2nd rung from the bottom.
AUTORETURN feature is set to REAR, documents exit the Scanner onto
the Stacker. The Stacker can be adjusted to any one of four positions by
raising or lowering it. The height of the Stacker should be adjusted to
accommodate the document being scanned. It has two extensions at its
end that can be pulled out to accommodate longer documents (up to size
E or A0). When scanning most common weight (20 lb, 80gsm)
documents, move the Stacker to the 2nd rung from the bottom.
NOTE: All thick documents and documents over 36 inches (914 mm)
exit from the rear of the Scanner (regardless of the AUTORETURN
setting). When scanning thick documents, the Stacker must be set to the
lowest position for optimum performance.
exit from the rear of the Scanner (regardless of the AUTORETURN
setting). When scanning thick documents, the Stacker must be set to the
lowest position for optimum performance.
B. Document Exit Slot
When the DOCUMENT RETURN feature is set to REAR, documents exit
the Scanner through this slot and are delivered to the rear Stacker.
the Scanner through this slot and are delivered to the rear Stacker.
C. Power On/Off Switch
This switch turns the Scanner on and off. Press this switch to the on (I)
position to turn on the Scanner and to the off (O) position to turn off the
Scanner.
position to turn on the Scanner and to the off (O) position to turn off the
Scanner.
D. The Power Cord supplies power to the Scanner. Plug one end of the
cord into the Scanner and the other end into an electrical outlet.
cord into the Scanner and the other end into an electrical outlet.
E.Status LED
The digital status LED provides an indication of the condition of the
scanner and communications with the controller. A P displayed on the
LED Display on the rear of the scanner indicates that the scanner is
operating normally and has established communications with the
controller.
scanner and communications with the controller. A P displayed on the
LED Display on the rear of the scanner indicates that the scanner is
operating normally and has established communications with the
controller.
F. IEEE 1394 Cable and Connector
The IEEE 1394 Cable is the communications link between the Scanner
and the Controller. Plug one end of the cable into either one of the IEEE
1394 connections at the rear of the Scanner. Plug the other end into the
IEEE 1394 connection on the Controller.
and the Controller. Plug one end of the cable into either one of the IEEE
1394 connections at the rear of the Scanner. Plug the other end into the
IEEE 1394 connection on the Controller.