Xerox IPS 用户手册
Printer controller overview
2-2
System Overview Guide
Printer controller components
The printer controller consists of a specially-configured Sun
workstation and uses proprietary Xerox hardware, firmware, and
software.
workstation and uses proprietary Xerox hardware, firmware, and
software.
Your system may use one of two platforms for the printer
controller:
controller:
•
Sun Blade 1000
•
Sun Ultra 60 workstation
Sun Blade 1000 workstation
The printer controller is based on the Sun Blade 1000, a
workstation with a high-performance architecture for complex
processing tasks. It contains the following hardware
components:
workstation with a high-performance architecture for complex
processing tasks. It contains the following hardware
components:
•
Processor (system unit) containing the following:
–
Two UltraSPARC III 750 Mhz central processing unit
(CPU) modules
(CPU) modules
–
4 GB memory (four 1 GB Dual In-line Memory Modules,
or DIMMs)
or DIMMs)
–
36 GB hard disk drive
–
DVD-ROM drive
–
3.5 inch diskette drive
•
Keyboard and mouse
•
Monitor
•
Optional Token Ring board
•
Two printer controller Interface (PCI) boards installed in the
processor to interface with the print engine.
processor to interface with the print engine.
Optional
components
For channel connection to a host for IPDS printing, the system
may use a channel interface board that is connected to a
channel cable connector box.
may use a channel interface board that is connected to a
channel cable connector box.
An external 4 mm tape drive is available and recommended for
backing up site files. A typical color calibration file is 1.5 MB.
backing up site files. A typical color calibration file is 1.5 MB.
A second internal 36 GB hard disk drive is optional, as are two
additional external disks.
additional external disks.