Xerox P12 用户手册

  

•

  

Chapter 4

Control Panel Button

The control panel button is used for many purposes, for example, to
pause/resume job processing, reset printer parameters, print status
page, or show the detail of fatal hardware errors.

The following table shows the effect of pressing the button under certain
conditions and for certain durations.

Ready

Momentary

Takes the printer off-line (Pause/Off-
line status)

10 seconds

The printer will print a settings page
which shows printer parameters.

In use

Momentary

Takes the printer off-line (Pause/Off-
line status) and execution of any job
will be withheld until the button is
pressed again.

Power-up

At power up
until all LEDs
double blink

Causes reset of non-volatile
parameters to the factory default
values.  The printer will first enter onto
the Diagnostic Processing status,
then all LEDs will start to double blink.
When this happens, release the button,
and LEDs will indicate the Initializing
status.  Then, it goes to the Ready
status.

During printing
job

Held down at
least 4
seconds

Resets the printer.  All printing jobs will
be canceled.  Light will cycle through all
LEDs as it does during Initializing
status until button is released.  Then,
the printer goes to the Ready status.

Pause/Off-line

Momentary

Resumes printing from pause; or go to
Ready status from Off-line status.

Printer functions associated with the Control Panel Button are not
executed until you release the buttons.