Xerox 8000 用户手册

DocuColor 8000/7000 Operator Manual

3-53

3. Accessories

Do not clean any area inside of the stacker/stapler unless 

otherwise directed by Xerox. If the stacker/stapler covers require 

cleaning, dampen a paper towel or soft, clean cloth with a liquid, 

nonabrasive glass cleaner or water.
To avoid damage to the stacker/stapler, do not pour or spray the 

cleaner or water directly onto the stacker/stapler. Always apply the 

liquid to the cloth first.
Do not use any other cleaners or solvents on the stacker/stapler or 

they may interact with the paint on the covers, eventually causing 

the paint to peel.

If after reviewing the Problems and following the recommended 

solutions the problem persists, call for assistance.

Fault Code 112-100

Jam indicated in 

stacker/stapler, but 

actually is in the Exit 

Module.

Jammed Paper not 

visible in stacker/stapler, 

and fault code does not 

clear after opening and 

closing stacker/stapler 

door.

•

Open the stacker/stapler door.

•

Jammed paper is not visible in the area indicated. 

Close the stacker/stapler door.

•

The UI indicates a jam in the Exit Module. Open 

the Exit Module and clear any visible sheets.

•

Open and close the stacker/stapler door.

•

Clear any other areas indicated on the UI.

Fault Code 112-100

Jam indicated in 

stacker/stapler.

No visible jams in 

stacker/stapler 

because sheet is 

located over the Exit 

Module sensor.

Paper jammed between 

Exit Module and 

stacker/stapler sensors

•

Open the stacker/stapler door.

•

Jammed paper is not visible in the area indicated. 

Close the stacker/stapler door.

•

If the fault code remains, open the Exit Module. No 

jammed sheets are visible.

•

Undock the stacker/stapler. Find the jammed 

sheet between the Exit Module and the 

stacker/stapler. Refer to the Note below this table 

for information on how to undock the 

stacker/stapler.

•

Clear any other areas indicated on the UI.