Xerox N2825 用户手册

❖

When you define a Tray Sequence, the printer searches 
the input trays for the correct size and type of paper for 
each job that is submitted.

• If you do not specify an input tray when sending a job 

to the printer (e.g., no paper source command is sent, 
or the paper source is set to “Auto” in PCL), the trays 
included in the Tray Sequence are searched first (in the 
sequence order), before other trays not in the 
sequence.

• If you specify an input tray when sending a job to the 

printer, and that tray is included in the Tray Sequence, 
the printer will check that tray for the correct size and 
type of paper.

— If the tray contains the correct paper, then it is 

used.

— If the tray does not contain the correct paper (e.g., 

it contains other paper or is empty), the other trays 
in the sequence are searched.

-

If any of these trays contains the correct paper, 
then it is used.

-

If any of these trays are set to the correct paper 
size and type but all of the trays in the sequence 
are empty, then the printer will prompt you to 
load paper into the specified tray.

-

If no trays in the sequence are set to the correct 
paper size and type, then the remaining trays are 
searched. If there are no trays that can satisfy the 
request, then the printer will prompt you to load 
paper into the specified tray.

• If you include “MBF” in the Tray Sequence setting, a 

request to feed paper from any other tray in the 
sequence will be overridden and the printer will 
attempt to feed paper from the multi bypass feeder 
first. If the multi bypass feeder is out of paper, then the 
other trays in the sequence are searched.