Xerox 6110 用户手册

Specifications

8.3

Acid Content

5.5 ~ 8.0 pH

Caliper

0.094 ~ 0.18 mm (3.0 ~ 7.0 mils)

Curl in Ream

Flat within 5 mm (0.02 in)

Cut Edge Conditions

Cut with sharp blades with no visible 

fray.

Fusing Compatibility

Must not scorch, melt, offset, or 

release hazardous emissions when 
heated to 180 °C (356 °F) for 0.1 
second.

Grain

Long Grain

Moisture Content

4 % ~ 6 % by weight

Smoothness

100 ~ 250 Sheffield

Face-down 

100 sheets of 75 g/m

2

 paper

Tray

150 sheets of 75 g/m

2

 paper

Manual feed mode

1 sheet of 60~163 g/m2 paper

Paper storage environmental conditions directly affect the feed 
operation.

Ideally, the printer and paper storage environment should be at 

or near room temperature, and not too dry or humid. 
Remember that paper is hygroscopic; it absorbs and loses 
moisture rapidly.

Heat works with humidity to damage paper. Heat causes the 
moisture in paper to evaporate, while cold causes it to 
condense on the sheets. Heating systems and air conditioners 

remove most of the humidity from a room. As paper is opened 
and used, it loses moisture, causing streaks and smudging. 
Humid weather or water coolers can cause the humidity to 

increase in a room. As paper is opened and used it absorbs any 
excess moisture, causing light print and dropouts. Also, as 
paper loses and gains moisture it can become distorted. This 

can cause paper jams.

Care should be taken not to purchase more paper than can be 
used in a short time (about 3 months). Paper stored for long 

periods may experience heat and moisture extremes, which 
can cause damage. Planning is important to prevent damage to 
large supplies of paper.

Unopened paper in sealed reams can remain stable for several 
months before use. Opened packages of paper have more 
potential for environmental damage, especially if they are not 

wrapped with a moisture-proof barrier.

The paper storage environment should be properly maintained 
to ensure optimum printer performance. The required condition 

is 20 to 24 °C (68 to 75 °F), with a relative humidity of 45 % 
to 55 %. The following guidelines should be considered when 
evaluating the paper’s storage environment:

• Paper should be stored at or near room temperature.

• The air should not be too dry or too humid.

• The best way to store an opened ream of paper is to rewrap 

it tightly in its moisture-proof wrapping. If the printer 
environment is subject to extremes, unwrap only the 
amount of paper to be used during the day’s operation to 

prevent unwanted moisture changes.

Envelope construction is critical. Envelope fold lines can vary 
considerably, not only between manufacturers, but also within 

a box from the same manufacturer. Successful printing on 
envelopes depends upon the quality of the envelopes. When 
selecting envelopes, consider the following factors:

• Weight: The weight of the envelope paper should not exceed 

90 g/m

2

 (24 lb) or jamming may occur.

• Construction: Prior to printing, envelopes should lie flat with 

less than 6 mm (0.25 in) curl, and should not contain air.