Xerox 721P85530 用户手册
PRINT FORMAT COMMANDS
6-68
XEROX DOCUPRINT 180 LPS PDL REFERENCE
IMAGE
This parameter specifies, for batch mode processing only, the initial
graphic imaging parameters to be used.
graphic imaging parameters to be used.
Syntax
OUTPUT IMAGE =
option(s)
Options
Table 6-50 lists the parameter option(s) and definition(s).
The default is top left corner scaled at 1/1.
Considerations
If the UN option is used to define positioning, the UNITS parameter
(described subsequently) must precede this command in the
parameter line.
(described subsequently) must precede this command in the
parameter line.
The IMAGE parameter must follow GRAPHICS=BATCH parameter,
as these two parameters are order dependent.
as these two parameters are order dependent.
If two IMAGE parameters are listed consecutively, the system will
process only the second one.
process only the second one.
Examples
OUTPUT GRAPHIC=BATCH,
IMAGE=(1 IN,2 CM);
IMAGE=(1 IN,2 CM);
Table 6-51.
IMAGE parameter option(s) and definition(s)
Option(s)
Definition(s)
vpos
Specifies the vertical position of the top edge of the
graphic, as an offset, relative to 0,0 on the current
physical page (the position that would be specified by
a PDE BEGIN of 0,0). This parameter is specified as
a decimal number with up to three digits to the right
of the decimal point and may be in the following units:
graphic, as an offset, relative to 0,0 on the current
physical page (the position that would be specified by
a PDE BEGIN of 0,0). This parameter is specified as
a decimal number with up to three digits to the right
of the decimal point and may be in the following units:
•
DOTS
•
centimeters (CM)
•
inches (IN)
•
user-defined unit (UN).
If no units are specified, inches are assumed. An xdot
is 1/600 unit of measurement.
is 1/600 unit of measurement.
hpos
Specifies the horizontal position of the left edge of the
graphic, as an offset, relative to 0,0 on the current
physical page. The form of the specification is the
same as for
graphic, as an offset, relative to 0,0 on the current
physical page. The form of the specification is the
same as for
vpos
.
[,
n
[/
d
]]
Specifies the reference scale factor. Each
parameter,
parameter,
n
and
d
, must be an integer in the range
of 1 to 8, thereby allowing a reference scale factor in
the range of 1/8 to 8. The reference scale factor is
multiplied with that specified at the time the graphic
was digitized and the product is rounded to the
nearest integer in the range 1 to 8. That integer
becomes the effective scale factor with which the
graphic is imaged.
the range of 1/8 to 8. The reference scale factor is
multiplied with that specified at the time the graphic
was digitized and the product is rounded to the
nearest integer in the range 1 to 8. That integer
becomes the effective scale factor with which the
graphic is imaged.