Xerox 2750 用户手册

2750 op#2 R3.doc  10-02

 

Page 2-2

 

 

 
 
 
 
 
 
 

The push-buttons on the operator’s control panel are “soft-programmed”, which means they are used for 
a number of tasks including selection of the fold program to be applied to incoming prints. The folder 
firmware includes over 50 fold programs (“tables”), up to 20 of which may be quickly accessed by the 
operator using the push-buttons. (The fold programs are listed in Chapter 4, and also in the Fold 
Directory. A separate set of up to 20 programs for hand feeding is also provided.  
 
In most cases the folder is connected to a host controller through its serial interface and when the folder 
is powered up the display will read ONLINE. If the folder is not connected to a host or the 
Communications mode is not set to “Normal”

 

the control panel displays the first four fold programs 

selected for your folder, as in the example below: 
 
1: 

8.5 x 11  PORT C 

8½” x 11” C-folded packet, portrait style 

8.5 x 11  LAND C 

8½” x 11” C-folded packet, landscape style 

9 x 12  PORT Z 

9” x 12” Z-folded packet, portrait style 

8.5 x 11  BkaZ     

8½” x 11” book-folded packet (Z fold only)  

 
In this sample display, fold program #2 is active, which means the folder will fold every incoming print 
(other than A-size sheets) into 8½” x 11” landscape packets. 
 
If more than four fold programs have been selected for your installation, press the MORE button to 
display. 
 

Receiver Advance 
Advances conveyor belts 
on High Capacity Print 
Receiver, if installed

Folder ON 

Handfeed 
Pressing the Handfeed push-
button switches the 2750 into 
hand-folding mode, displaying a 
modified list of programs. The 
print to be folded is fed into the 
rollers at the rear of the folder 
(image face-down, title block 
leading - centering is not 
important, but alignment is). 

 

Indicates a fault/jam 
condition, or open cover 

have similar control panels, with 
plain language in place of icons, 
e.g., MORE in place of +>