Xerox 2750 用户手册

2750 op#2 R3.doc  10-02

 

Page 2-14

 

 

 
4.  Open the lower clam shell and remove the document. 
 
5.  Close and lock the lower clam shell, then reattach the crossfold section to the accordion folder. 
 
6.  Replace the hitch pin to lock the crossfold and accordion fold sections, then lower and lock the upper 

section of the crossfolder, and replace the rear cover. 

 

 
NOTE: It is normally not necessary to remove the cover from the upper section of the crossfolder. This is 
for service access only. 
 
Press the two crossfolder latches, then raise the upper crossfold section. Observe the safety 
precaution. Remove the document, then close and lock the upper section. 
 

CROSSFOLD POCKET and CROSSFOLD EXIT 

 
1.  Open the upper crossfold section. 
 
2.  Remove the rear panel. 
 
3.  If the fold packet is caught in the upper nip rolls, and enough of it is exposed, grasp it and pull upward 

to remove. You may need to use the crank handle, turning it clockwise. Be sure there are no torn 
pieces of paper remaining in the upper nip rolls. 

Crossfolder rear panel 
Remove the rear panel for access to the 
lower section of the crossfolder, including 
the hub for the crank handle used to clear 
jams.

 

Unhitching the accordion and cross folder 
Once the hitch pin has been removed, the crossfolder may be 
detached from the accordion folder. The lower clam shell is 
then accessible through the rear of the accordion folder. The 
lower clam shell, and its center lock, is identical to the upper.

 

 

When replacing 
the rear panel, 
take care not to 
damage the 
interlock switch. 

Unplug the power cord before 
unhitching the crossfolder.