Xerox 490 用户手册
Appendix
Xerox 490/980 Color Continuous Feed Printing System
A-2
Printer Operator Guide
Offset Specification and Logical Page Size Explained
The two sets of numerical values that make up the Offset Specification and the Logical Page
Size are dependent on two variables:
Size are dependent on two variables:
1.
The DPI (dots per inch) selected in the imposition file, which can be either:
•
300x300 DPI or;
•
600x600 DPI
2.
The width of the logical page (image area) being printed.
Note
In the following paragraph, it mentions that a logical page size of 5.6 in (142 mm) by 12 in
(305 mm) is used. This is because 5.6 in (142 mm) by 12 in (305 mm) is the size of the test
pattern printed to perform color calibration using the Xerox 490/980 Color Continuous Feed
Printing System SIR.
(305 mm) is used. This is because 5.6 in (142 mm) by 12 in (305 mm) is the size of the test
pattern printed to perform color calibration using the Xerox 490/980 Color Continuous Feed
Printing System SIR.
Later in this chapter, there is a
. This table
shows the numerical values for the Offset Specification and Logical Page Size for widths of
paper stock from 8.3 (211 mm) in to 19.5 in (495 mm) and a logical page size of 5.6 in (142
mm) by 12 in (305 mm).
paper stock from 8.3 (211 mm) in to 19.5 in (495 mm) and a logical page size of 5.6 in (142
mm) by 12 in (305 mm).
If the width of the paper stock you are using is not covered in the
, use the sample procedure in the section
to determine the appropriate numerical values.