Xerox 5400 用户手册

Step-by-step setup (AppleTalk)

Configuring EtherTalk at the control panel

To enable the EtherTalk protocol at your printer’s control panel, follow these steps:

1.

Press Menu Up or Menu Down until you see:

2.

Press Item Up or Item Down until you see:

3.

Press Value Up or Value Down. You should see:

4.

Press Enter. You should see:

5.

Press On Line. You should see:

6.

Restart the printer.

Selecting the printer from the Chooser

Before you send a print job to the Phaser 5400 printer, make sure that it is selected as the 
current printer in the Chooser.

1.

At the printer, print a Configuration Sheet and note the EtherTalk Name. Refer to the 
Quick Network Install Guide for instructions.

2.

At your computer, select the APPLE in the upper left corner of the Desktop.

3.

Select the Chooser entry in the menu.

4.

Make sure that AppleTalk is active.

5.

In the left window of the Chooser, click on the Adobe PS icon to select it. You may 
have to use the scroll bars at the right side of this box to locate the icon.

Your network may be divided into AppleTalk Zones. You can tell if there are 
zones by the appearance of the CHOOSER window. When the CHOOSER 
program detects multiple zones, the left window is reduced in size. The lower 
half of the CHOOSER window is a zone list. Identify, then select the zone in 
which the Phaser 5400 printer is located.