Xerox 604P18057 用户手册

Along with fault codes, the following messages are displayed on the touch screen in 
some occasions.

116-749

The print job was stopped because the specified font was not found. Install the 
font or enable font replacement in the print driver.

116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778

The parameter values were corrected because the machine encountered a 
problem when printing the data. If the received image is incomplete or 
damaged, ask the other party to check the image or to resend the data. When 
Internet Fax forwarding is enabled, check with the recipient if they received the 
image intact.

116-780

There is a problem with the document attached to the received e-mail. Check 
the attached document.

124-701

Due to a malfunction in the specified tray, the output destination was changed to 
the center output tray. Contact the Xerox Welcome Center. Use a different 
paper tray.

A fault has occurred.
Switch off the machine. Ensure that the 
screen disappears before switching it on.
If the problem persists, call for service. 

A fault has occurred. Switch off the machine 
and wait until the touch screen is turned off 
completely, and then restart the machine. If 
the problem persists, write down the fault 
code (xxx-yyy) displayed on the screen. 
Switch off the machine and contact the Xerox 
Welcome Center.

A fault has occurred. The machine has 
rebooted. If the problem persists, call for 
service. 

The machine was restarted due to a fault. 
Resume normal operations. If the problem 
persists, contact the Xerox Welcome Center.

Processing has been cancelled due to an 
error.
See User Guide for information on fault code. 

The machine operation has stopped due to a 
fault. Restart the job.