Epson 100 用户手册
Insert the loop-back connector. Then press Y
and
Enter to
start the check.
First, the computer checks the serial port control lines to see
that they are able to change from high to low and vice versa.
that they are able to change from high to low and vice versa.
No messages are displayed during this part of the test unless an
error occurs.
The second test is an echo back check during which the port
sends data to itself in a fixed data format, at all the possible
baud rates. When this test begins, you see these messages:
baud rates. When this test begins, you see these messages:
RS232C echo back check - at various
baud rates
Current
baud
rate is 75
Current test
data
is 00
Each baud rate is tested in turn, and the display informs you of
the progress of the test. If the port does not become ready
correctly, a timeout error occurs. If any data received does not
match the data
match the data
sent,
a verify error occurs, and the computer
reports the transmitted and received data at the time of the
error.
The final test is an echo back check during which the port
sends data to itself at 9600 baud, using various data formats.
At the start of the test, you see these messages:
RS232C echo back check - with various
data
formats
Current data format: 5 data bits, 1 stop
bits,
parity-NONE
Current
test data is 00
Once again, if any data received does not match the data sent,
a verify error occurs, and the computer reports the transmitted
and received data at the time of the error.
and received data at the time of the error.
Performing System Diagnostics
D-29