FARGO electronic S000256 用户手册

RESTRICTED USE ONLY 

 

FARGO Electronics, Inc. 

4 

a.  Insert the Cleaning Card into the Card Hopper, above the Card Input Tray, 

as normally done with any other type of card.  

b.  Be sure, however, that the shortest non-adhesive end of the Cleaning 

Card enters the Printer first and that the sticky side is facing UPWARD.   

  Caution:  If the card is inserted with the sticky side facing downward, 

it will stick to the Card Input Tray and will not feed. 

5 

Once the Cleaning Card is properly inserted into the Card Hopper, hold down 
the On/Cancel button and push the Cleaning Card into the Printer until the 
second gray feed Roller grabs and begins feeding the card. 

6 

a.  Continue to hold down the On/Cancel button until the Cleaning Card has 

fed completely through the Printer.   

b.  Repeat this cleaning procedure as needed.  

c.  After the cleaning procedure is finished, re-install media, close the 

Printer's Top Cover, and turn the Printer power OFF and ON to reset the 
Printer. 

7 

Be sure to use either clear tape or masking tape.  (Note:  If the cleaning kit is 
not available, adhesive tape is also an effective method for removing lint and 
debris from the Rollers.) 

  Caution:  Do not use duct or strapping tape.  These adhesives leave 

a gummy residue behind.   

8 

a.  Open the lid, and use the Pause/Resume and On/Cancel buttons to 

rotate the main feed Rollers, while applying the tape.   

b.  Alternatively, use 99% pure alcohol wipe.  Do not use these wipes for 

every cleaning because this could eventually deplete the tact from the 
Roller’s rubber.  

(Warning:  Do not use alcohol to clean the Cleaning Roller Assembly.) 

 

Persona

® C25 Card Printer User Guide (Rev. 4.0) 

134