Primera Technology C-1000 用户手册
Command Language Quick Reference 25
Appendix A: Command Language
Quick Reference
This section lists all internal software commands for the printer
if you are installing it in a legacy application in which a
specific printer programming language is being used. For
more information please refer to the Programmers Manual,
available separately from the factory or your Authorized
Reseller. This section does not apply if you are using the
printer with the included Windows-compatible driver and
Windows application software.
A. COMMAND SET FOR PPLA
The following commands are for Printer Programming
Language A.
System Setting Commands
These commands will cause related parameters to be saved in
These commands will cause related parameters to be saved in
the permanent storage, E2PROM. The parameters will be
stored unless they are changed by commands or a reset from
the front panel.
Command
Description
Parameter
Factory default
<STX>KI4n
Media empty
n: 0 - disable
enabled
check
1 - enable.
<STX>KI7n
Set ribbon
n: 0 DT,
TT with ribbon
mode
1 TT.
<STX>KI8n
Set baud rate
m: 0 9600,
9600 baud.
1 600,
2 2400,
3 19200,
4 4800,
5 38400,
6 1200,
7 9600.
<STX>KI;1
Select alternate
!KI;0 - selects
Control codes
standard
control
codes.
<STX>KXnnnn
Set continuous
nnnn: a 4-digit
Valid under
label length
number,
Windows driver
in mm
Label Dr.
510172_r1.qxd 3/21/2001 6:25 PM Page 25