Primera Technology LX400 用户手册

Tear Off Position

If Output Mode (described later in this section) is set to

Present, the printer will present your labels over the Tear Bar

for easy removal.  This tear off position is set at the factory.  

If fine tuning is needed to align the break in your label stock

over the Tear Bar, increase this setting to eject the label further;

decrease this setting to eject the label stock less.  The unit of

measure is 0.1 mm.

Cut Position

If a label cutter attachment is connected to the printer you can

fine tune the cut position between the labels. Increase this

value to move the label further out before the cut; decrease 

this value to eject the label stock less before the cut.

Left Margin Offset

This will be factory calibrated. If fine tuning is needed, increase

this setting to move the image right on the label; decrease this

setting to move the image to the left on the label. The unit of

measure is 0.1mm.

Top of Form (TOF)

This setting allows you to fine tune the print starting position

on your label stock.  This will be factory calibrated.  If fine 

tuning is needed, increase this value to move the image down

on the label. Decrease this value to move the image up the

label.  The unit of measure is 0.1mm.
Click the Test Offsets button

to send a test print to the

printer that will help you

adjust the TOF and Left

Margin Offset.  The printer

will print the pattern shown.

Adjust the values so that both

black bars print on the label

with no white space on the

label and no ink on the liner.

+

+

-

-

LEFT OFFSET

TOF

(10 units)

1.0 mm

510984.qxd  11/21/2006  9:09 AM  Page 42