Ricoh AP610i 用户手册

Paper and Other Media

Loading Envelopes

As there are many kinds of envelopes, be sure to check if those to be used are
supported by this printer.

For more information about envelopes, see

❒ Even if the optional envelope feeder is not installed, you can select envelope

sizes for Tray 2 and Tray 3 using the control panel. However, you cannot load
envelopes until the optional envelop feeder unit is installed.

❒ To install the envelope feeder unit, the optional paper feed unit must be in-

stalled. See “Attaching Envelope Feeder Type 610”, Setup Guide.

Loading envelopes onto the Bypass Tray

With the bypass tray, you can load up to 10 envelopes at the same time. For
more information about envelopes, see

To open and close the bypass tray, see

Load envelopes until they stop, with the print side up and the sides of
the flaps on the left as shown below.

❒ Confirm that the envelope flaps are securely folded down, and that there is

no air inside the envelopes.

❒ Confirm that the top of the stack is not higher than the limit mark on the side

guides.

❒ Do not push the stack of envelopes with too much force.

Slide the side guides against the edge of the envelope stack.