Lexmark 4069-XXX 用户手册
Diagnostic Information
2-79
4069-XXX
No indication that Bin X is Full OR No indication that Bin X is Near
Full
Full
High-Capacity Output Stacker Service Check
Service Tip: The majority of the mechanical components can be
observed during operation by removing the left, right and front
covers. The high capacity output stacker option functions without the
covers installed.
observed during operation by removing the left, right and front
covers. The high capacity output stacker option functions without the
covers installed.
Models 010 and 010n do not support this output option.
Determine which paper path stacker assembly is not functioning
properly.
properly.
Make sure the option(s) are installed correctly and the machine is
configured correctly before attempting to service the high-capacity
output stacker option.
configured correctly before attempting to service the high-capacity
output stacker option.
to identify the
correct jumper location at J6 for the upper and lower units.
FRU
Action
1
Dual Output Bin X Sensor
Assembly
Control Board
Assembly
Control Board
Check for correct installation of
the sensor cable at J5 on the
control board. If either the Bin Full
(F) or Bin Near Full (NF) fail the
sensor test then check the voltage
at J5-3 and J5-4. The voltage
measures approximately +5 V dc.
If the voltage is incorrect, replace
the control board. If correct,
replace the sensor assembly.
the sensor cable at J5 on the
control board. If either the Bin Full
(F) or Bin Near Full (NF) fail the
sensor test then check the voltage
at J5-3 and J5-4. The voltage
measures approximately +5 V dc.
If the voltage is incorrect, replace
the control board. If correct,
replace the sensor assembly.