Lexmark X746de 用户手册
Resetting the maintenance counter
Reset the maintenance counter after installing the new photoconductors. Use any one of the following procedures:
When a “replace” or “low” message does not appear
Follow this procedure when the photoconductors are replaced and no “replace” or “low” message appears:
1
From the home screen, navigate to:
> Supplies Menu > Replace Supply.
2
Touch the buttons that indicate which of the four photoconductors you replaced.
•
All
•
Cyan Photoconductor
•
Magenta Photoconductor
•
Yellow Photoconductor
•
Black Photoconductor
3
When [color] photoconductor replaced appears, touch Yes.
4
Touch
to return to the home screen.
When a “replace” or “low” message appears
Follow this procedure when the photoconductors are replaced and 84 Replace [color] photoconductor,
84 [color] photoconductor nearly low
84 [color] photoconductor nearly low
, or 84 [color] photoconductor low still appears:
1
From the home screen, navigate to:
Status/Supplies > Supply Replaced
2
When Replaced [color] photoconductor appears, touch Yes.
Notes:
•
All four photoconductors should be replaced at the same time for optimum print quality.
•
Ready
appears when the counter is reset.
Moving the printer
Before moving the printer
CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injury or
printer damage:
printer damage:
•
Turn the printer off using the power switch, and then unplug the power cord from the wall outlet.
•
Disconnect all cords and cables from the printer before moving it.
•
Use the handholds located on both sides and rear of the printer to lift it.
•
Make sure your fingers are not under the printer when you set it down.
Maintaining the printer
249