Lexmark 752 用户手册
55
Configure for TCP/IP
7
Press
Menu
until you see Set IP Netmask, and then press
Select
.
8
Repeat step 6 to set the IP Netmask.
9
Press
Menu
until you see Set IP Gateway, and then press
Select
.
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press
Go
to return the printer to the
Ready state.
Verifying the IP
settings
settings
1
Print another network setup page. Look under the “TCP/IP”
heading and make sure the IP address, netmask, and gateway
are what you expected. See “Printing a network setup page” on
page 53 if you need help.
heading and make sure the IP address, netmask, and gateway
are what you expected. See “Printing a network setup page” on
page 53 if you need help.
Note:
On Windows
computers, click Start
Programs Command
prompt (or Accessories
Command prompt if using
Windows 2000).
Programs Command
prompt (or Accessories
Command prompt if using
Windows 2000).
2
Ping the printer and verify that it responds. For example, at a
command prompt on a network computer, type “ping” followed
by the new printer IP address (for example, 192.168.0.11):
command prompt on a network computer, type “ping” followed
by the new printer IP address (for example, 192.168.0.11):
ping 192.168.0.11
If the printer is active on the network, you receive a reply.
Configuring for
Pull Printing
Pull Printing
If your printer has an optional Lexmark ImageQuick™ firmware card
installed, you can configure for Pull Printing once an IP address is
assigned to the printer.
installed, you can configure for Pull Printing once an IP address is
assigned to the printer.
For detailed configuration instructions, refer to the CD that shipped
with the Lexmark ImageQuick card.
with the Lexmark ImageQuick card.