KYOCERA FS-1020D 用户手册

Parallel Interface

B-2

B.1 Parallel Interface

B.1.1 Parallel Interface Communication Modes

The printer features fast data transmission on the parallel interface. The 

parallel interface mode can be activated from the KM-NET for Clients 

utility contained on the Kyocera Mita Software Library CD-ROM supplied 

with the printer as follows:

The printer automatically changes its communication mode to the one the 

host computer is currently using. Ordinarily, you should leave this setting 

unchanged.

High speed data communication is used in compliance with the IEEE 1284 

standard.

The printer uses the standard communication method prescribed for 

Centronics interfaces.

This mode enables faster data transmission between the printer and the 

host computer. (Select this mode if printing problems occur when the 

printer is connected to a workstation.)

B.1.2 Interface Signals

The pins of the parallel interface connector carry the signals listed in 

. Asterisks in the table indicate signals that are active low. The 

table also indicates whether each signal is incoming or outgoing with 

respect to the printer.

Note