Seiko Instruments SLP 410 用户手册

1  Install the software, then connect the printer to your PC or Mac.

•  The SLP can be connected to either the Serial or USB port on

your PC. Do not use both cables. On your Mac use the USB port.

•  Connect the other end of the cable into

the appropriate port on the back of the SLP.

2  Connect the supplied AC adapter to the

back of the SLP and to a power outlet.

3  Press the button to turn the printer on.

The status light will flash until the labels are loaded.

4  Lift the label cover.

5  Load a roll of standard labels.

•  Remove the sticker from the roll, and then place

the roll on the spindle as illustrated. If using an
SLP 420, 430, 440 or 450, adjust the label guides
to fit against the roll.

•  Feed the labels into the slot on the back of

the printer. The labels automatically feed to
the exit slot, then stop.

•  Close the label cover.

6  Start your SLP software and begin using your

new SLP. If you want to run a test label, please
refer to the FAQ “Test Labels” on our website:
www.siibusinessproducts.com.