IBM 1xR 用户手册
station or document insert station by a preset amount, until the document
exits the feed rollers. If a cutter is available at the station (CR station only),
it cuts the paper.
exits the feed rollers. If a cutter is available at the station (CR station only),
it cuts the paper.
Print and feed paper n lines
Syntax:
ESC d n or X'1B64;n'
Where:
n
Specifies the number of line-feeds.
Purpose:
Prints data in the print buffer and feeds the paper by the amount specified
in this command.
in this command.
Print and feed paper using minimum units
Syntax:
ESC J n or X'1B4A;n'
Where:
n
Specifies the line feed steps.
In the receipt station: 1 in. = 204 steps (1 mm = 8 steps).
In the document portrait station: 1 in. = 51 steps (1 mm = 2 steps).
In the document landscape station: 1 in. = 127 steps (1 mm = 5
steps).
steps).
Note:
Line spacing dimension is approximate. For the impact printer in
portrait mode, the actual line spacing must be calculated using 51
steps per inch.
portrait mode, the actual line spacing must be calculated using 51
steps per inch.
Purpose:
Prints data in the print buffer and feeds the paper by the amount specified
in this command.
in this command.
Print graphic messages
Select and print a graphics (logo) command
This command can be used to print signature captures at the printer.
1.
1.
Capture the signature as a bitmap.
2.
Convert the bitmap to a series of graphics (logo) messages.
3.
Hold the buffer.
4.
Send the graphics messages to the printer.
5.
Release the buffer.
Syntax:
ESC * d w h data or X'1B2A;d;w;h;data'
Where:
d
Dot density.
00
Normal Print - 200 dpi in the receipt station, 150 dpi in the
document station.
document station.
Chapter 2. Communication parameters
65