Sony AR-208S 用户手册

下载
页码 311
- 2 -
SAFETY STANDARDS
Notice for Users in U.S.A.
Declaration of Conformity
SHARP Network Expansion Kit, AR-NB2 A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1)  This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation.
Responsible Party: SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430
TEL:
1-800-BE-SHARP
Shielded cables must be used with this equipment to maintain compliance with 
standards.
Notice for Users in Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
For users in the USA
This device complies with Part 15 of the FCC rules. Operation is subject to the 
following two conditions: (1) This device may not cause harmful interference, 
and (2) this device must accept any interference received, including interference 
that may cause undesired operation.
WARNING:
FCC Regulations state that any unauthorized changes or modifications to this 
equipment not expressly approved by the manufacturer could void the user’s 
authority to operate this equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference by one or more of 
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.


♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠
♠♠♠♠♠♠♠♠♠♠♠
♠♠
♠♠
♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠
♠♠
♠♠
♠♠♠♠♠♠♠♠♠♠
♠♠♠♠♠♠♠♠♠♠♠♠♠♠
♠♠♠
♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠
♠♠♠
♠♠♠♠♠♠♠♠♠♠♠
♠♠♠
♠♠♠♠♠♠♠♠♠♠♠
♠♠
♠♠
♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠♠
♠♠
♠♠
♠♠♠♠♠♠♠♠♠♠
♠♠