Sony AR-208S 用户手册

When the network expansion kit is installed in the machine, the following programs are added to the 
user programs for Print mode.
The IP address and other network settings are configured using these user programs.

The procedure for selecting a user program setting is explained in "SELECTING A SETTING FOR 
A USER PROGRAM" in the operation manual.

Settings (factory 

default settings 
appear in bold)

4

ENABLE TCP/IP

1: YES
2: NO

This program must be enabled to use the 
machine on a TCP/IP network. "IP ADDRESS 
SETTING" must also be configured.
This program is initially enabled (factory default 
setting).

5

ENABLE DHCP

1: YES
2: NO

If "YES" is selected (factory default setting) and 
the machine is connected to a TCP/IP network, 
the IP address will be acquired automatically.
If you will manually assign an IP address using 
"IP ADDRESS SETTING", select "NO".

6

IP ADDRESS 
SETTING

• IP ADDRESS
• SUBNETMASK
• DEFAULT GATEWAY

This program is used to set the IP address (IP 
address, Subnet Mask, and Gateway) of the 
machine when TCP/IP protocol is used on the 
network.
When "ENABLE DHCP" is selected, the 
machine will obtain an IP address 
automatically. This is the factory default setting.

7

ENABLE 
NETWARE

1: YES
2: NO

This program must be enabled to use the 
machine on a network that uses NetWare 
protocol.
This program is initially enabled (factory default 
setting).

8

ENABLE 
ETHERTALK

1: YES
2: NO

This program must be enabled to use the 
machine on a network that uses EtherTalk 
protocol.
This program is initially enabled (factory default 
setting).

9

ENABLE 
NETBEUI

1: YES
2: NO

This program must be enabled to use the 
machine on a network that uses NetBEUI 
protocol.
This program is initially enabled (factory default 
setting).