Zebra Technologies P1043301-005 用户手册

Getting Started
Determining the Active Print Server

P1043301-005  

11/21/13

Your active print server selection is dependent on the model of printer or print engine that you 

have.

S4M

ZT210

ZT220

ZT230

Only one print server (wired or wireless) can be installed at a 
time. Thus, the print server installed is the primary print server.

105SL

XiIIIPlus

R110Xi

R170Xi

Z4Mplus

Z6Mplus

R110PAX4

You may select which installed device is the primary network 

device. The printer will try to use the primary network device as 
the active print server before trying the other installed options.

These printers and print engines use X60.16.x or later firmware. 
The default for the printer is to skip the check for a wired print 
server during bootup. This makes the wireless print server the 
primary network device if a wireless print server is installed. To 
change this default and allow the wired print server to be the 
primary network device when it is connected, use one of the 
following methods to tell the printer to check for a wired print 
server at bootup time:

the WIRED PS CHECK parameter on the control panel

the ^NB ZPL command

 identifies which device becomes the active print server 

under various conditions.

Xi4

R110Xi4

ZD500R

ZM400

ZM600

ZT410

ZT420

RZ400

RZ600

ZE500

105SLPlus

These printers support the simultaneous installation of an 
internal, external, and a wireless print server. Even though all 
three print servers may be installed, only one is connected to the 
network and is the active print server. 

 outlines priorities and identifies which device becomes 

the active print server when multiple print servers are installed.

You may select whether the wired or wireless print server will be 

the primary connection by using one of the following methods:

the PRIMARY NETWORK parameter on the control panel 

the ^NC ZPL command