Zebra Technologies Z6Mplus 用户手册
Troubleshooting
Printer Diagnostics
13163L Rev. 3 5/20/2004
Z4Mplus/Z6Mplus User Guide
97
PAUSE Self Test
This self test can be used to provide the test labels required when making adjustments to the
printer’s mechanical assemblies or parameter settings. See the sample printout in
printer’s mechanical assemblies or parameter settings. See the sample printout in
Figure 41 • PAUSE Test Label
To perform the PAUSE Self Test, complete these steps:
1.
Turn the printer Off (
O
).
2.
Press and hold
PAUSE
while turning On (
l
) the printer.
3.
Release
PAUSE
after the DATA light turns off (approximately five seconds).
The printer prints 15 labels at 2 in. (51 mm) per second, then automatically pauses. If
PAUSE is pressed, an additional 15 labels print.
PAUSE is pressed, an additional 15 labels print.
4.
Press
CANCEL
while the printer is paused to alter the self test, then press
PAUSE
.
The printer prints 15 labels at 6 in. (152 mm) per second, then automatically pauses.
5.
Press
CANCEL
again while the printer is paused to alter the self test again, then press
PAUSE
.
The printer prints 50 labels at 2 in. (51 mm) per second, then automatically pauses.
6.
Press
CANCEL
again while the printer is paused to alter the self test a third time, then
press
PAUSE
.
The printer prints 50 labels at 6 in. (152 mm) per second, then automatically pauses.
7.
Press
CANCEL
again while the printer is paused to alter the self test a fourth time, then
press
PAUSE
.
The printer prints 15 labels at the printer’s maximum speed.
8.
To exit this self test at any time, press and hold
CANCEL
.