Zebra Technologies Z6Mplus 用户手册

Serial Data Port

13163L Rev. 3 5/20/2004

Z4Mplus/Z6Mplus User Guide

103

The connection for this standard interface is made through the female DB-9 connector on the 
rear panel. A DB-9 to DB-25 interface module is required for all RS-232 connections through 
a DB-25 cable (see 

 for details).

For all RS-232 input and output signals, the printer follows both the Electronics Industries 
Association’s (EIA) RS-232 specifications and the Consultative Committee for International 
Telegraph and Telephone (CCITT) V.24 standard signal level specifications.

 shows the pin configuration and function of the rear panel serial data connector on 

the printer.

1

—

Not connected

2

RXD

Receive data—data input to printer

3

TXD

Transmit data—data output from printer

4

DTR

Data terminal ready—output from printer

5

SG

Signal ground

6

DSR

Data set ready—input to printer

7

RTS

Request to send—output from printer

8

CTS

Clear to send—input to printer

*9

+5 V DC

+5 VDC

*  This pin is also available as a +5 VDC power source at 750 mA. To enable this capability, a 

jumper on the computer’s main logic board needs to be installed on JP1, pins 2 and 3.

An interface module is required for RS-422/RS-485 interface support 

(see

).