Zebra Technologies Z6Mplus 用户手册
48
Z4Mplus/Z6Mplus User Guide
13163L Rev. 3 5/20/2004
Printer Operation
Install Memory Card
Install Memory Card
The printer can use Type I or Type II compliant PCMCIA memory cards.
To install the PCMCIA memory card, complete these steps:
1.
Remove the PCMCIA card shield from the rear of the printer.
2.
Insert the PCMCIA card, with the notch UP, into the card slot as shown (see
Figure 31
).
Insert the card far enough to cause the eject button to pop out.
Figure 31 • Installing the PCMCIA Card
3.
Reinstall the PCMCIA card shield over the PCMCIA card and card slot.
The printer is now ready to operate with the additional memory or font option.
The printer is now ready to operate with the additional memory or font option.
Electrostatic Discharge Caution • Observe proper electrostatic safety precautions when
handling any static-sensitive components such as circuit boards and printheads.
handling any static-sensitive components such as circuit boards and printheads.
Note •
The PCMCIA card is hot-swappable. It can be installed while the printer is On (
l
).
Note •
Initialization of the PCMCIA card may take a few minutes; the PAUSE LED flashes
while the card initializes. If the card is already initialized, the PAUSE LED flashes only once
or twice. To verify that the card has successfully initialized, print a configuration label and
review it to see if the new memory card information is listed.
or twice. To verify that the card has successfully initialized, print a configuration label and
review it to see if the new memory card information is listed.
Card Eject
Button
Notch
PCMCIA
Card
F
u
s
e
F
u
s
e