Zebra Technologies Z6Mplus 用户手册
Configuration
Overview
13163L Rev. 3 5/20/2004
Z4Mplus/Z6Mplus User Guide
51
Exit Configuration Mode
You can leave configuration mode at any time.
To exit configuration mode, complete these steps:
1.
From the front panel, press SETUP/EXIT.
The
The
SAVE CHANGES
display appears.
2.
Press PLUS (+) or MINUS (–) to scroll through the choices (
Table 8
):
3.
Press SELECT to select the displayed choice.
4.
Press SETUP/EXIT to save your choice.
Table 8 • Save Options When Leaving Setup Mode
LCD Display
Description
PERMANENT
Permanently saves the changes. Values are stored in the printer even when power
is turned off.
is turned off.
TEMPORARY
Saves the changes until you change them again or until power is turned off.
CANCEL
Cancels all changes from the time you pressed
SETUP/EXIT
except the
darkness and tear-off settings (if they were changed).
LOAD DEFAULTS
Sets all parameters other than the network settings back to the factory defaults.
To see the factory default values, see
To see the factory default values, see
Configuration and Calibration LCD
Displays on page 57
.
Note •
Loading factory defaults causes the printer to auto-calibrate.
LOAD LAST SAVE
Loads values from the last permanent save.
DEFAULT NET
Sets the wired and wireless network settings back to factory defaults.