Zebra Technologies Z4Mplus 用户手册
Printer Setup
Calibration
Z4Mplus and Z6Mplus User Guide
15
Calibration
Auto Calibration
The Z4Mplus and Z6Mplus automatically calibrate on power up. During auto
calibration, the printer determines the label length and sensor settings.
calibration, the printer determines the label length and sensor settings.
Auto calibration occurs when the printer is turned on and each time the printer
recovers from an error condition. To clear an error, open and close the printhead
assembly and then press PAUSE. The printer begins auto calibration when all errors
have been cleared.
recovers from an error condition. To clear an error, open and close the printhead
assembly and then press PAUSE. The printer begins auto calibration when all errors
have been cleared.
The results of the auto calibration are stored in the printer's memory and are retained
even if printer power is removed. These parameters remain in effect until the next
calibration is performed.
even if printer power is removed. These parameters remain in effect until the next
calibration is performed.
,
Note • If the front panel setting for MEDIA POWER UP or HEAD CLOSE are set
to LENGTH, NO MOTION, or FEED, the printer starts printing without auto
calibrating.
to LENGTH, NO MOTION, or FEED, the printer starts printing without auto
calibrating.