Zebra Technologies Z4Mplus 用户手册
Printer Setup
Basic Configuration
Z4Mplus and Z6Mplus User Guide
23
Basic Configuration Process
See the instructions below to perform basic a configuration:
1. Enter the configuration mode by pressing SETUP/EXIT.
DARKNESS displays.
2. If there is no print darkness problem, press PLUS (+) to move to the next option,
Print Speed.
If the labels moved forward, but the print is light or there is no print, increase the
darkness.
darkness.
If the print is too dark, or the ribbon sticks to the media, decrease the darkness.
3. Press SELECT.
4. Press PLUS (+) to increase the darkness or MINUS (–) to decrease the darkness.
5. Press SELECT to accept the change.
6. Press PLUS (+) to move to the next option.
PRINT SPEED displays.
7. If the image is crisp, press PLUS (+) to move to the next option, Tear-Off.
If the print is dark enough, but the image is not crisp, slow down the print speed.
Print speed is given in inches per second (ips).
Print speed is given in inches per second (ips).
8. Press SELECT.
9. Press PLUS (+) to increase the speed or MINUS (–) to decrease the speed.
10. Press SELECT to accept the changes.
11. Press PLUS (+) to move to the next option.
TEAR OFF displays.
The Tear Off position defines the position of the label on the tear-off bar. When
working with non-continuous labels, the inter-label gap should be on the tear bar.
working with non-continuous labels, the inter-label gap should be on the tear bar.
If the label gap is lining up on the tear bar, or if you are using continuous material,
press PLUS (+) to move to the next option, Print Mode.
press PLUS (+) to move to the next option, Print Mode.
12. If the position of the label needs to be adjusted, press SELECT.
13. Press PLUS (+) to move the label forward or MINUS (–) to move the label back.
14. Press SELECT to accept the changes.