Motorola MVME2600 用户手册
MVME761 Transition Module Preparation
http://www.motorola.com/computer/literature
1-27
1
Serial Ports 1 and 2
On MVME761-compatible models of the MVME2603/2604 base board,
the asynchronous serial ports (Serial Ports 1 and 2) are configured
permanently as data circuit-terminating equipment (DCE). The port
configuration is illustrated in
the asynchronous serial ports (Serial Ports 1 and 2) are configured
permanently as data circuit-terminating equipment (DCE). The port
configuration is illustrated in
.
Configuration of Serial Ports 3 and 4
The synchronous serial ports, Serial Port 3 and Serial Port 4, are
configurable through a combination of serial interface module (SIM)
selection and jumper settings. The following table lists the SIM connectors
and jumper headers corresponding to each of the synchronous serial ports.
configurable through a combination of serial interface module (SIM)
selection and jumper settings. The following table lists the SIM connectors
and jumper headers corresponding to each of the synchronous serial ports.
Port 3 is routed to board connector J7. Port 4 is available at board
connector J8. Eight serial interface modules are available:
connector J8. Eight serial interface modules are available:
❏
EIA-232-D (DCE and DTE)
❏
EIA-530 (DCE and DTE)
❏
V.35 (DCE and DTE)
❏
X.21 (DCE and DTE)
You can configure Serial Ports 3 and 4 for any of the above serial protocols
by installing the appropriate serial interface module and setting the
corresponding jumper. SIMs can be ordered separately as required.
by installing the appropriate serial interface module and setting the
corresponding jumper. SIMs can be ordered separately as required.
Synchronous
Port
Board
Connector
SIM
Connector
Jumper
Header
Port 3
J7
J1
J2
Port 4
J8
J12
J3