Lenovo 9859 用户手册
10.
Slide the power-supply assembly toward the front of the chassis and remove
it from the computer.
it from the computer.
11.
Install the new power-supply assembly into the chassis so that the screw holes
in the power-supply assembly align with those in the chassis.
in the power-supply assembly align with those in the chassis.
Note:
Use only the screws provided by Lenovo.
12.
Install and tighten the four screws at the rear of the chassis to secure the
power-supply assembly.
power-supply assembly.
13.
Check the position of the voltage-selection switch on the rear of the computer.
Use a ballpoint pen to slide the switch, if necessary.
Use a ballpoint pen to slide the switch, if necessary.
Note:
Some computers do not have a voltage switch. These computers
automatically control the voltage.
automatically control the voltage.
v
If the voltage supply range is 100–127 V ac, set the switch to 115 V.
v
If the voltage supply range is 200–240 V ac, set the switch to 230 V.
14.
Reconnect all the power supply cables to the drives and the system board.
15.
162
Hardware Maintenance Manual