Brady 200M-e 300 用户手册

Bradyprinter 200M-e and 200M-e 300 User’s Guide

33

(Peel option required)

Refer to Figure 19.

1. Press the printhead open lever.  The printhead assembly springs up.

2. Slide out the media supply guide as far from the printer frame as 

possible.

3. Place the roll of media on the media supply hanger.

4. Slide in the media supply guide so that it just touches, but does not 

restrict, the edge of the roll.

5. Feed the media under the inner media guide in the print mechanism.

6. Pull approximately 36" (915 mm) of media through the front of the 

printer.

7. Ensure that the media is against the inner media guide.  Then, slide in 

the outer media guide so that it just touches, but does not restrict, the 
edge of the media.

8. Close the printhead assembly.

9. Remove the hook from the take-up spindle shaft.

10. Remove several labels from the media backing and then wind the 

backing 1-2 times around the media take-up spindle and reinstall the 
hook.

NOTE:  If your printer has a peel with a rewind option, then you 
need to remove the rewind plate and store it on the mounting screw 
on the inside of the front panel before proceeding to step #9 above.