Brady 200M-e 300 用户手册
42
Bradyprinter 200M-e and 200M-e 300 User’s Guide
&KDQJLQJ3DVVZRUG3URWHFWHG3DUDPHWHUV
Certain parameters are password-protected by factory default.
CAUTION: Do not change password-protected parameters
unless you are sure you know what you are doing! If the
parameters are set incorrectly, they could cause the printer to
function in an unpredictable way.
unless you are sure you know what you are doing! If the
parameters are set incorrectly, they could cause the printer to
function in an unpredictable way.
The first attempt to change one of these parameters (pressing either the (+)
or (–) key) requires you to enter a four-digit password. This is done via the
“ENTER PASSWORD” display. The (–) key changes the selected digit
position; the (+) key increases the selected digit value. After entering the
password, press the NEXT/SAVE key. The parameter you wish to change
is displayed. If the password was entered correctly, you can now change
the value.
or (–) key) requires you to enter a four-digit password. This is done via the
“ENTER PASSWORD” display. The (–) key changes the selected digit
position; the (+) key increases the selected digit value. After entering the
password, press the NEXT/SAVE key. The parameter you wish to change
is displayed. If the password was entered correctly, you can now change
the value.
The default password value is 1234. The password can be changed using
the
the
^KP
(Define Password) ZPL II instruction or through BradyConnect
when the appropriate print server is used.
NOTE: Once the password has been entered correctly, it does not
have to be entered again unless you leave and re-enter the
programming mode using the SETUP/EXIT key.
have to be entered again unless you leave and re-enter the
programming mode using the SETUP/EXIT key.
NOTE: You can disable the password protection feature so that it
no longer prompts you for a password by setting the password to
ØØØØ via the
no longer prompts you for a password by setting the password to
ØØØØ via the
^KPØ
ZPL/ZPL II command. To re-enable the
password-protection feature, send the ZPL/ZPL II command
^KPx
,
where “x” can be any number, one to four digits in length,
except Ø.
except Ø.