Brady 3000 用户手册

Printer-Applicator-System PAM 3000

5 Mounting the Applicator

Installation

1. Put the applicator at the left side of the PAM 3000 printer using the four holes (1).

2. Fasten the applicator by screwing the four screws (4) including the washers.

CAUTION !

Make sure that the two bolts at the rear side of the applicator are inserted into the

long hole (2) and the guide hole (3) on the side of the printer.

Fig. 5a

Installing the applicator

2
1

3
1

3. Plug the connector of the applicator's electronic system (7) in the peripheral port (6) of the

PAM 3000 printer.

4. Push the compressed air tubes of the applicator (5) into the appropriate push-in-fittings (8)

on the top of the PAM 3000 printer. The appropriate tubes and fittings are marked by

figures.

Fig. 5b

Connecting the applicator

6
7