Fujitsu BS2OSD 用户手册

 

Page 12

 

 
Previously, it was only possible to reorganize closed files in 

pubsets or volumes with SPACEOPT.  
As of SPACEOPT V3.0, open files can also be included when reor-

ganizing pubsets and reducing file extents. 
Please consult the Release Notice SYSFGM.SPACEOPT.030.E for the 

complete scope of the innovations.  
 

 

 
Block sizes ranging from 32 KB to 256 KB are supported for tape 

I/O with the BTAM access method for record formats V and U, to 
allow high-performance backups to be made.  

The new block size is specified at the TPR-FCB program interface. 
The function is only available in TPR and for users with the TSOS  

  *1 

or HSMS-ADMINISTRATION privilege. 
Large tape blocks are supported by the products ARCHIVE V7.0B, 

FDDRL V15.0 and PERCON V2.8  
 

 

 
Data encryption fulfills the requirements for the security of 

critical data, such as protection against physical reading from 
the disk, protection against unauthorized reading, also with TSOS 

special rights, protection against unauthorized usage of backup 
tapes or monitoring the data contents with file transfer connec-

tions. 
The files are stored on the disk in encrypted form and decrypted 

in blocks for an authorized access in the system/server. The 
files are taken over encrypted into backups or during file trans-

fers. 
Two special commands have been introduced for encrypting and de-

crypting a file. An eight character crypto password is defined 
for each file that is to be encrypted/decrypted. The key for en-

cryption/decryption is then derived from this during access.  
 

ENCRYPT-FILE:   converts a normal file into an encrypted file 
DECRYPT-FILE:   converts an encrypted file into a normal file 

 
Working with encrypted files and the crypto password is similar 

to working with ID-protected files and the file password. The 
crypto password is registered as an access right with the command 

ADD-CRYPTO-PASSWORD. This registration is valid for the current 
task. The access right can be removed again with the command 

REMOVE-CRYPTO-PASSWORD. 
 

  *1 

The openCrypt-Serv 1.2 subsystem with a corresponding Crypto Box  

  *1 

is required for file encryption on S servers. 

  *1 

openCRYPT-SOFT 1.2 in conjunction with X2000 as of V3.0A are  

  *1 

required for encryption on the SX100-C and SX150 servers. 

  *1 

An additional crypto CPU is required on SX150, whereas the  

  *1 

encryption processes run on the X2000 CPU on SX100-C