Echo PAS-2601 TYPE 1E 用户手册

1.  Loosely attach bracket (A) to shield (B) and attach to bottom of 

 

gear housing (C) with screws and nuts provided.  Tighten all 

 

attaching hardware.

 

2.  Install upper plate (D) on splined PTO shaft. Blade installation  

requires use of Upper Plate (D) with 20mm pilot. 

3.  Place Blade (E) over upper plate pilot, install the Lower Plate (F)  

and 10mm LH nut (G).

4.  Insert Locking Tool (K) through hole in upper plate and notch in  

gear housing to prevent PTO shaft from turning.  Tighten nut  

and secure with Split Pin (L).

The Barrier Bar is required when using grass or weed blades.  Units 

equipped with U-Handles do not require installation of the Barrier 

Bar.

1.  Remove screws and nuts and back plate from handle.

2.  Position front handle on shaft and install Barrier Bar using four (4) 

5x35 mm screws and (4) new nuts included with kit.  Handle must 

be at least 10 inches (250 mm) from center of rear handle grip.

3.  Adjust handle position for comfortable operation, and tighten 

screws securely. 

 

2.  Position front handle on shaft and install Barrier Bar using two 

(2) 5x35 mm screws provided in kit.  Handle must be at least 10 

inches (250 mm) from center of rear handle grip.

3.  Adjust handle position for comfortable operation, and tighten 

screws securely.

The Barrier Bar is not a handle.