Chaney Instrument 13230 用户手册

Introduction

Thank You for purchasing this Acurite

product. Please read through this

manual in itʼs entirety to fully enjoy the benefits and features of this

product. Please keep this manual for future reference.

NOTE: A protective film is applied to the LCD at the factory that must be

removed prior to using this product. Locate the clear tab and simply peel

to remove.

Overview

SETUP

Battery Choice & Temperature Range

Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause

alkaline batteries to function improperly. This will cause the outdoor

wireless sensor to stop transmitting temperature readings. Use lithium

batteries in these low temperature conditions to ensure continued

operation for wireless sensors placed outdoors. NOTE: Rechargeable

batteries are not recommended due to higher operating voltages.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY

SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove

battteries from equipment which is not to be used for an extended perid of time. Follow the polarity (+/-) diagram in the battery

compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same

or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as

batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use

rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

Installing Batteries - Wireless Sensor

Installing Batteries - Display Unit

Remove the battery

compartment cover. Install

2 fresh “AA” batteries as

shown here.

BATTERIES

MUST BE INSTALLED FOR

THE SENSOR TO OPERATE

Remove the battery

compartment cover.

Install 3 fresh “AA”

batteries into the

battery compartment.

Replace the battery

compartment cover.

Outdoor

Temperature

Intelli-Time

Clock

Month,Date

Pressure

Graph

Outdoor

Humidity

A/B/C Wireless Selection

To allow for more than one weather station and wireless sensor

network to be used in close proximity, the display unit and the

wireless sensor have a small switch labeled “A B C” within the

battery compartments. This switch selects one of 3 wireless modes

to use, and both switchs MUST be set in matching positions (either A,

B, or C) fore wireless communication to take place successfully.

Weather

Forecast

Moon Phase