MGE UPS Systems ESV 8+ 用户手册
mains
outlet
outlet
I max 3.4A
Ue/In/Eing
10A/250V
1
2
4
5
Network Protection
IN
OUT
to computer
systems
systems
Us/Out/Ausg
I max 3.4A
1
2
8
7
7a 7b
MGE UPS SYSTEMS
Pulsar ESV 8+/11+/14+/22+ EB 22/EB 22XLA : 86-153277-00
11
getting started
location
■
observe the safety rules indicated at the
beginning of this document.
preliminary checks
■
check that button
3
"
" on
the front is not pushed in;
■
check that rating shown on identification
plate
10
corresponds to the input volt-
age specification and power requirement of
the load.
the load.
connections
■
power connections:
■
■
Pulsar ESV 22+ only: connect battery
connection cord
19
to Pulsar ESV 22+ and
connect to Pulsar EB22,
■
■
use the computer cord to supply input
power to Pulsar as shown.
■
serial connections:
If you wish to use the functions of the
CD-ROM supplied with your Pulsar, con-
nect one end of the supplied serial cable
CD-ROM supplied with your Pulsar, con-
nect one end of the supplied serial cable
14
to the communication port 9 .
Connect the other end to a serial port of a
computer system.
computer system.
■
computer network protection:
If you wish to use the network line filtering
functions (Ethernet for example), use a
cable of the RJ45 type. Connect the "IN"
output to the network and use another cable
to connect the "OUT" output to the protect-
ed computer system.
functions (Ethernet for example), use a
cable of the RJ45 type. Connect the "IN"
output to the network and use another cable
to connect the "OUT" output to the protect-
ed computer system.
Connect the computer cord
5
between
the UPS power input receptacle
4 , and
a nearby power outlet,
■
■
use included EEC cords
8
to con-
nect the computer loads to output sockets
7 ,
7 ,
7a
and
7b
.
Note 1:
Following connection, the battery automatical-
ly charges, regardless of the position of the
ON/OFF button
Following connection, the battery automatical-
ly charges, regardless of the position of the
ON/OFF button
3
"
" .
Note 2:
The batteries will provide full back-up time
after approximatively 8 hours of recharge
time.
The batteries will provide full back-up time
after approximatively 8 hours of recharge
time.
Note 3:
The rating of the input power cord must be not
less than the nominal input rating of Pulsar.
The rating of the input power cord must be not
less than the nominal input rating of Pulsar.