Asrock AM2XLI-ESATA2 产品宣传页

2 2

2 2

2 2

2 2

2 2

Clear CMOS

Default

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•

Floppy Connector

(33-pin FLOPPY1)
(see p.11  No. 24)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

FLOPPY1

Pin1

the red-striped side to Pin1

2.7

2.7

2.7

2.7

2.7

Jumpers Setup

Jumpers Setup

Jumpers Setup

Jumpers Setup

Jumpers Setup

The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is “Short”. If no jumper cap
is placed on pins, the jumper is “Open”. The
illustration shows a 3-pin jumper whose pin1
and pin2 are “Short” when jumper cap is
placed on these 2 pins.

PS2_USB_PWR1

Short pin2, pin3 to enable

(see p.11,  No. 1)

+5VSB (standby) for PS/2 or
USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by

power  supply.

Clear CMOS Jumper

(CLRTC1)
(see p.11,  No. 9)

Note: CLRTC1 allows you to clear the data in CMOS. The data in CMOS includes

system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3
on CLRTC1 for 5 seconds.