Toshiba 125 用户手册

G8000 Series Installation and Operation Manual

mode.
The output of the UPS will continue uninterrupted to the load. The unit 

must be in the bypass mode at the time that the breaker is placed in 

the “OFF” position for the UPS to shutdown power to the load.

until the UPS internal circuits have been fully discharged.
The UPS could be damaged if the unit is not fully discharged before 

the breaker is reset.

input frequency range must be within the rated input frequency range.

3) The UPS should not be used with a load that has a rated input that is greater than the 

rated output of the UPS.

4)  If using the UPS to provide power to motors that require high starting current or with 

motors that require a long starting time, call Toshiba support for guidance in over sizing 

the UPS for lock rotor current.

5) DO NOT insert metal objects or combustible materials in the ventilation slots of the UPS.
6) DO NOT place, hang, or paste any objects on the exterior surfaces of the UPS.
7) The capacitors in the UPS maintain a residual charge for a while after turning the UPS 

off. The required discharge time for each UPS typeform is provided via a cabinet label 

and a 

CHARGE LED. Wait for at least the minimum time indicated on the label and 

ensure that the 

CHARGE LED has gone out before opening the door of the UPS once 

the UPS power has been turned off.

8) DO NOT attempt to disassemble, modify, or repair the UPS. Call your Toshiba sales 

representative for repair information.

9) Turn the power on only after installing 

ALL of the covers.

10) DO NOT remove any covers of the UPS when power is on.
11) If the UPS should emit smoke or an unusual odor or sound, turn the power off immediately.
12) Warning signs should be placed on or near the load as a notification that the load is 

being powered by the UPS.

13)  Additional  warnings  and  notifications  shall  be  posted  at  the  equipment  installation 

location as deemed required by 

Qualified Personnel.